The matters need attention of ball mill working

1, Start checking each part of the ball mill machinery and electrical good, check the connecting bolts are loose; lubricate all lubrication points are normal, normal transmission reliability, guards intact, electrical instruments are sensitive, motor brush contact.
2 jigger week to check whether the device around rotating parts or obstacles and eliminated. When people start not allowed to stand around.
3, After the check, press the start button to start the motor, note the current changes. Ball no more than two consecutive start, the first and second every 5 minutes or more, if the third starter, must electrician, fitter with the same check before starting. Not be combined with other devices in the same starting staggered start to avoid tripping.
4, the normal operation of the ball mill, we must strictly follow the water, to the mining, steel balls to add provisions prohibiting overload, idle time is not more than 15 minutes, so as not to bash liner.
5, the operation should be careful to check whether the leakage of plasma cylinder, careful observation of current, voltage, feeding, water supply is normal, check once every half hour, and the spindle motor temperature not greater than 60 ° С, identify problems in time.
6, the operation to observe the hollow shaft, rotating with oil if the oil ring hollow shaft temperature is normal, if found hollow shaft fever, near Burnt, forced cooling measures should be taken immediately, shall immediately stop running, so as to avoid "hold Axis. " While paying attention to check the oil lubrication, temperature, time to refuel.
7, Ball mill should be stop feeding before parking, standby in concentration after the treatment, stop water supply. Stop button, pull the switch.8, In the absence of notice of blackout, the first pull down the knife, press the stop button to stop the mine, water supply.
9, After the shutdown, cleaning and sanitation equipment to ensure civilized production.