Ball mill is an important crushing, grinding mining equipment .After the completion of a ball mill equipment installation, must carry on the preliminary trial run. First ball mill commissioning by skilled operatives responsible for , and strictly comply with safety procedures ball . The following for you to make a few notes:

1 , when the ball mill commissioning at least 12-24 hours of continuous operation time , operation found the problem to be resolved in a timely manner .

2 , into the ball 2/3 of the number of balls 24-48 hours after commissioning , check and tighten all bolts again.

3 , a ball mill test run was cooled lubrication system should work. Main bearings, transmission bearing , reducer temperature should be normal .

4 , increased by more than three points and the length of the load test run time to running- gear and gear case size as a basis for determining the gear . Before contact with the tooth surface accuracy does not meet the design requirements, may not operate at full capacity .

5 , should seriously carry out commissioning work of the record.

6 , mill air operation can be carried out properly load test machine commissioning . Load test run should be carried out in stages . Load operation should be conducted , as the nesting feeding, avoid unnecessary ball and cylinder liner wear loss and damage.